Making Setting Of "F6: System" Menu - Furuno FS-1575 Service Manual

4.14.4 Making Setting of "F6: System" Menu

Pressing the [F6]: System will display the window shown below.
To make "Slave Delay" setting and return this menu to "Default," the password should
be entered.
When the "Default" menu is executed, the set values of "System" will return to the
default.
Setup
Slave Delay
TX/RX MSG Save
Edit Before sending
Time System
Time & Date
Window Color
Self Test
Setting Procedure)
1) Press the [F6] key to display the System menu.
2) Put the cursor on [Change], and then move down the cursor to a Submenu to be set
to make setting of this Submenu. However, "Slave Delay" cannot be selected.
Procedure for making "Slave Delay" setting and returning the setting to "Default")
1) Press the [F6] key to display the System menu.
2) Type the password: "DP6" in capital letter.
3) To make "Slave Delay" setting, put the cursor on [Change].
To return the "System" setting to the factory set, put the cursor on [Default], and
then press the [Enter] key.
Meaning of Each Item
• Slave Delay
When operating in the ARQ mode, the called station employs a constant time
interval between the end of the received signal and the start of the transmitted
signal. It can be arbitrarily set in the range of 0 to 50 msec, but leave the setting as
default. "8 msec"
CONFIDENTIAL (internal use only)
This confidential document is used only by FURUNO authorized persons.
It is strictly prohibited to reproduce the document in whole or in part without prior written permission of FURUNO.
System
Lock Change
8 msec ( 0 - 50msec )
OFF ON
OFF ON
OFF UTC STM JST
2012 / 01 / 13 12:10:10
4-101
4.14 IB-583 Setting
Default