Ap2.2 Messages Related To Setting Errors - Furuno FS-1575 Service Manual

34.
DUPLICATE RELAY ALL message received! [CANCEL]: Stop alarm
An alarm sound goes off when a Relay All message is received. The condition for
stopping this alarm sound is that the [CANCEL] key is pressed.
35.
DUPLICATE RELAY AREA message received! [CANCEL]: Stop alarm
An alarm sound goes off when an Area Relay message is received. The condition
for stopping this alarm sound is that the [CANCEL] key is pressed.

AP2.2 Messages related to Setting Errors

36. The unit will not transmit any DSC call until own ship's MMSI is entered.
[CANCEL]: Stop alarm
A warning alarm sound goes off. It goes off when the system starts up or a DSC
call is transmitted without making MMSI setting. The condition for stopping this
alarm sound is that the [CANCEL] key is pressed.
37. Lost position!! Position was older than 23.5H. You must update position!
[CANCEL]: Stop alarm
A warning alarm sound goes off. It goes off when 23.5 hours or more have elapsed
after the last update of the own ship's positional information. The condition for
stopping this alarm sound is that the [CANCEL] key is pressed.
38. Position data is not updated! Position was older than 4H.
Update it. [CANCEL]: Stop alarm
A warning alarm sound goes off. It goes off when four hours have elapsed after the
last update of the own ship's positional information. The condition for stopping
this alarm sound is that the [CANCEL] key is pressed or the positional information
is updated.
39. EPFS error [CANCEL]: Stop alarm
A warning alarm sound goes off. It goes off when the transmission of positional
information from GNSS is lost for a period of 10 minutes.
However, when "INPUT TYPE" is set to "Manual," this alert will not go off. The
condition for stopping this alarm sound is that the [CANCEL] key is pressed or the
positional information from GNSS is updated.
40. Cannot Print. Check Printer. [CANCEL]: Stop alarm
A warning alarm sound goes off. It goes off when printing paper runs out during
printing, anyone tries to print without setting printing paper on the printer, or a
print request for data size exceeding the allowable range of the printer is
transmitted to make the printer buffer full. The condition for stopping this alarm
sound is that the [CANCEL] key is pressed.
CONFIDENTIAL (internal use only)
This confidential document is used only by FURUNO authorized persons.
It is strictly prohibited to reproduce the document in whole or in part without prior written permission of FURUNO.
AP2-5
Appendix 2. Message List