Ap1.5.5 Executing Clear All - Furuno FS-1575 Service Manual

AP1.5.5 Executing CLEAR ALL

Normally, to execute the CLEAR ALL menu, press the [S1] key on the T-IF board of the
FS-xx75T unit, and then enter the password.
General Menu Manager allows for executing the CLEAR ALL menu without
performing the operation aforementioned.
CLEAR ALL:
General Menu Manager: SERVICE MENU -> MMSI SETUP -> CLEAR ALL
Procedure)
1. Boot General Menu Manager, and then connect it to the FS-xx75 system.
1) [MENU] -> 9.SERVICE -> 7.OTHER -> P-BROWSER -> ON;
2) Communication -> LAN Connect Settings -> Connect
3) Main -> Connect Target
2. Ensure that General Menu Manager is set to "NORMAL MODE."
3. Click on SERVICE MENU in the menu tree -> MMSI SETUP -> "CLEAR ALL."
"operation button" for the CLEAR ALL menu will be displayed on the Main
window.
4. Click on the [START] key on the Main window.
5. When the "STATUS" display switches to "CLEAR END," the CLEAR ALL menu
is completed.
6. Set values except MMSI and MAC address are cleared. Make setting of these
values again.
CONFIDENTIAL (internal use only)
This confidential document is used only by FURUNO authorized persons.
It is strictly prohibited to reproduce the document in whole or in part without prior written permission of FURUNO.
STATUS Display
[START] Key
AP1-23
Appendix 1. Parameter Browser