Additional Information: Updating Program Via Serial Port - Furuno FS-1575 Service Manual

Additional information:
Updating Program via Serial Port
1. Program file
Program folder (SIOuppg) and their contents are indicated in the table below.
File
FSXX75.BIN
LDALL576.BIN
upALL57600.bat
uppg.exe
2. Connection
Connect the PC to FS-2575C (No.1) unit.
9 Pin D-sub cable wiring between PC [Serial] port and Control unit [NBDP] port as shown in
below.
[Serial]
Note)
(1) Connect the PC to FS-2575C (No.1).
(2) If PC is connected to FS-2575C (No.2), the program cannot be updated.
3. Serial Port
If the serial port on the PC is anything other than [COM-1], change the specified COM port to
[COM-1] on the PC, or edit the batch file "upFPGA57600.bat" as shown in below.
UPPG.exe LDALL576.BIN FSXX75.BIN 0 0 0 1 1
CONFIDENTIAL (internal use only)
This confidential document is used only by FURUNO authorized persons.
It is strictly prohibited to reproduce the document in whole or in part without prior written permission of FURUNO.

Additional information: Updating Program via Serial Port

Size Category
7,019 kB BIN File
24 kB BIN File
MS-DOS
1 kB
Bat File
Application
84 kB
File
8-21
Table.1 Program File List
Note
Application file
Loader program
For receiving and writing data in FS-xx75
Batch file
For updating the program
Loader program
For transmitting data from PC to FS-xx75
[NBDP]
COM port number