Table of Contents
Advertisement
This section explains how to install and set up the projector. If you are familiar with the projector and want to quickly
set it up for temporary use, follow the Quick Setup instructions below. For a more complete setup, follow the
instructions and guides covered in the remaining subsections.
NOTES: 1) The lens is not mounted when the projector is shipped from the factory. For instructions on how to install
or replace a lens, refer to 4.5, Replacing the Lens. 2) This manual assumes the optional decoder is installed.
2.1
Quick Setup
STEP 1
STEP 2
STEP 3
STEP 4
Installation & Setup
Follow these steps for quick setup of the projector in a standard floor mount position.
Position the Projector
'
Set the projector at the expected throw distance (projector-to-screen distance) and
center the lens with the screen. See 2.3, Projector Position and Mounting and
Appendix E. Refer also to the dimensioned diagrams of the projector provided in
Section 5. Make sure that the projector is level from side-to-side (see 2.7, Leveling),
adjusting feet if necessary.
Connect a Source
'
Locate the main input panel at the rear of the projector. The lower left area, labeled
INPUT 1
, accepts an RGB input via BNC connectors. The upper right area (assuming
an optional video decoder is installed) accepts a composite video at
INPUT 4
video input at
Connect the Line Cord to AC Power
'
Connect the projector's line cord to the AC receptacle at the lower right rear corner of the
projector and to proper AC. Input power required is 100 - 240 VAC, 50 to 60 Hz @ 9 amps
(@ 100 V). Use the line cord provided with the projector. See Section 5.
Do not attempt operation if the AC supply and cord are not
within the specified voltage and power range. See Section 5.
Turn the Projector ON
'
Using the remote keypad, press
projector on (or press
POWER
The
LED, located in the lower right corner of the rear input panel, should
glow a steady green.
. Connect your source to the appropriate panel connectors.
WARNING
Power*
and hold for approximately 1 second to turn the
Power*
ON
). Let the projector warm up for about five minutes.
S e c t i o n 2
INPUT 3
or S-
DLV1280 DX User's Manual
2-1
Advertisement
Table of Contents
