Table of Contents
Advertisement
OPERATION
3-10
DLV1280 DX User's Manual
NOTE: Once
Func
non-numeric entry until 2 digits have been entered or until 5 seconds of inactivity
have elapsed.
Use of the
Func
key within the menu system is noted with the appropriate topic
elsewhere in Section 3. For example, press
deletion or copying of a channel.
OSD (On-screen display)
OSD*
Press and hold
OSD*
visible or invisible). Or press
guarantee the correct toggle direction (useful if you are unsure of the present status).
Note that invisible menus are fully functional.
NOTE: With OSD on, you can still mute menus, error messages, slidebars, etc. with
the appropriate setting in the Menu Preferences menu.
Help
Help
Press
Help
for detailed information about any current menu and highlight. Press
again to exit. From presentation level, press
consisting of Using Help, Setup, Keys, Source (Input) Selection, Status/Pwr LEDs
and Using 3D. Press
Test
Test
Press
Test
to display one of the available test patterns. Press
next available pattern in the sequence.
at any time to remove the current test pattern from the screen and return to
presentation level. Test patterns are also accessible from within the menu system.
NOTE: For a list of test patterns, see 3.7, Configuring System Parameters
(Communications menu).
Keypad operating settings (protocols)
The remote keypad and the optional wired keypad both store keypad operating
settings (called protocols) in memory. In some advanced applications, such as when
you want to use two separate keypads to control two projectors independently, you
may want to override the original protocol set at manufacture (which is "A or B") for
one of the keypads. See section 2.10, Keypad Protocols and Conversion for complete
instructions.
Func
= Red
Func
= Green
Func
= Blue
Func
= Red and Green
Func
= Green and Blue
Func
= Red and Blue
Func
= All colors (
is pressed in presentation level, the projector will not respond to
for approximately 1 second to toggle menus on or off (i.e.,
OSD*
followed immediately by
Exit
to leave General Help and return to presentation level.
Test
Exit
does the same thing)
Func
in the Channel Setup menu to enable
ON
or
Help
to access the General Help menu
Test
again to display the
will exit after the last pattern, or press
OFF
to
Help
Exit
Advertisement
Table of Contents
