Christie DLV1280 DX User Manual page 16

RGB Signals
'
INPUT 1
connection would be to an RGB source such as VGA, SVGA, XGA, Mac,
PowerMac, DEC, Sun, SGI and others. This projector supports multiple sync types
with RGB signals: sync-on-green, composite sync, and separate H & V syncs.
NOTE: Depending on the source, you may need a custom adapter cable with BNC
connectors at the projector end and a different type of connector at the other (such as
a 15-pin "D" connector for computer sources). Contact your dealer.
Connect the
outputs to the
sync-on-green, only the red, green, and blue connections are required. If the source
provides a composite sync output, connect it to the
the source provides separate horizontal and vertical sync outputs, connect horizontal
sync to the
labeled
NOTES: 1) If for some reason the projector fails to recognize as an RGB signal,
specify this Color Space option within the Image Settings menu. See 3.6, Adjusting
the Image. 2) To connect YPbPr signals–such as from DVD or analog HDTV sources–to
INPUT 1
section.
provides 5 BNCs (connectors) for linking to a variety of sources. The typical
SYNC
BNC input(s) first. Then connect the red, green and blue source
RED GREEN
, , and
SYNC
input labeled
VERT.
See Figure 2.13.
, use the red, green and blue BNCs as described in YPbPr Signals later in this
Figure 2.13. Connecting RGB Input
BLUE INPUT 1
BNCs on the
SYNC
HOR/COMP
and connect vertical sync to
INSTALLATION & SETUP
panel. If the source uses
HOR/COMP
input labeled
SYNC
DLV1280 DX User's Manual
. If
input
2-13