Using The Keypad - Christie DLV1280 DX User Manual

3.3 Using the
Keypad
IR Remote
STATUS/POWER LEDS -
corner of the rear connector panel indicate projector "Status" (top) and "Power"
(bottom). During normal operation, the "Power" light is steady green and the "Status"
light flashes green each time a key is pressed or when the projector receives a serial
command. Use the following as a guide:
NOTE: A steady red power light accompanied by a coded pattern of red and yellow
flashes from the status light indicates an internal system error. See 3.11, Error
Conditions. Should the problem persist, contact a qualified service technician
available through your dealer.
REMOTE WIRED KEYPAD CONNECTOR (3-pin XLR) -
control of the projector.
HARD RESET -
Emergency access for powering down the projector in the event of a
system failure. Insert a pen point or small screwdriver.
The keypad appears in two locations:
•
Infrared (IR) Remote for tetherless control up to 100 feet away
•
Wired Remote (optional) tethered to the rear of the projector
While either keypad is identical in layout and provides complete control of the
projector, you may find one keypad more convenient than the other for your specific
installation and application.
'
The IR Remote Keypad controls the projector by way of wireless communications
from a battery-powered infrared (IR) transmitter. Use the IR remote keypad the same
way you would use a remote keypad supplied with a TV or VCR. When making key
presses, point the keypad either toward the screen or toward the front of the projector.
Two LEDs (light emitting diodes) located in the lower right
Figure 3.2. Reading the Status LEDs
OPERATION
For optional tethered remote
DLV1280 DX User's Manual
3-3