INSTALLATION AND SETUP
2-30
DLV1280 DX User's Manual
•
Plug the keypad cable (available separately) into the empty battery
compartment. Make sure that the battery cover is notched smoothly to
accommodate the cable.
•
Set keypad protocol as desired, using "wired" jumper settings.
•
Replace battery compartment cover.
•
Plug into the 3-pin XLR port at the rear panel of the projector.
TO CHANGE FROM WIRED TO INFRARED:
•
Unplug the keypad from the projector.
•
Open the keypad back and unplug the keypad cable.
•
Wait 1-2 minutes.
•
Install batteries (see Section 4).
•
Set keypad protocol as desired, using "IR" jumper settings.
•
Replace battery compartment cover.