Christie DLV1280 DX User Manual page 81

OPERATION
Controlling One Projector
Broadcasting to
All Projectors
Tiling An Image
Across Multiple Displays
3-48
DLV1280 DX User's Manual
Menu
Press and select the Configuration menu, then the Communications submenu.
Scroll down to "Projector#" and enter a three-digit number (000 to 999) for
identifying the current projector. Press
Repeat for each projector, using a unique three-digit number for each. Once every
projector has its own number, you can begin to control the group.
'
If your projectors are networked, first make certain that only one (any) projector has
its "Broadcast Keys" option selected (checked) and IR sensor enabled—the
remaining projectors must have the "Broadcast Keys" option unchecked and their
keypads disabled (do this in Communications menu). The "Broadcast Keys" projector
will then relay keypad commands to the other projectors. If using a wired remote,
make sure to select the "Broadcast Keys" option for the projector to which the wired
remote is connected.
To work with a single projector in a network, press
window from each projector. Enter the three-digit number you have assigned to the
projector you wish to control. All keypad commands will then affect this projector
exclusively until you press
to broadcast mode (below).
NOTE: If you are using a computer or controller to issue commands, use the correct
RS-232 software command to gain control of a single projector.
'
First make certain that only one projector has its "Broadcast Keys" option selected
(checked) — the remaining projectors must have the option unchecked and their
keypads disabled (do this in Communications submenu). The "Broadcast Keys"
projector will then relay keypad commands to the others. If using a wired remote,
make sure to select the "Broadcast Keys" option for the projector to which the wired
remote is connected.
On either the IR remote or wired keypad, press
Press again without entering a number — the keypad commands will now affect
all projectors.
NOTE: If you are using a computer or controller to issue commands, use the correct
RS-232 software command to broadcast.
'
Tiling an image means that multiple adjacent
displays work together to form a single image,
like a tiles in a mosaic. This videowall concept
contrasts with other multiple-projector
applications in which each display is a
complete and independent image. Use the
Tiling Setup menu as described below
(accessed via the Size and Position menu or
Configuration/Geometry menu) to configure a maximum of 16 displays (4 x 4) into
one single-image videowall or tiling array.
Defining the Videowall
NUMBER OF ROWS –
your videowall. Each projector must have the same setting.
Enter to accept the entry, or
again and enter a different number, or until you switch
Use the slidebar to define the number of rows (1-4) present in
Exit to cancel.
to display an editable
to display the projector box.