Christie DLV1280 DX User Manual page 104

STEP 1
Turn off the projector, cool, and unplug.
'
Before removing or installing a lens, turn off the projector and allow to cool for five
minutes before unplugging. Make sure that the lens cap is on.
STEP 2 Loosen the 3 lens mount screws
'
•
IF FIXED LENS:
ball driver provided with the
projector to loosen the 3 lens
mount screws that secure the lens
flange to the mount–loosen these
screws only, do not remove. See
Figure 4.9.
•
IF ZOOM LENS:
mount screws is likely blocked by
the toothed zoom ring in front of it.
First rotate the zoom ring by hand
until its 3 access holes align with the
screws, then insert the hex socket
ball driver through the holes to
loosen the screws–do not remove.
See Figure 4.10.
WARNING
Unplug the projector.
Install the lens cap.
Use the hex socket
Access to the 3 lens
MAINTENANCE
Figure 4.9. Loosen 3 screws
– FIXED LENS –
Figure 4.10. Align zoom gear ring
to access 3 screws
– ZOOM LENS –
DLV1280 DX User's Manual
4-9