Table of Contents
Advertisement
OPERATION
3-6
DLV1280 DX User's Manual
Input 4
Input4
Press
Input4
to select the source connected to
is the same as entering
Input
Input
Press
Input
when you want to display from a specific source location, such as a
switcher connected serially to the projector's switcher port. The first digit represents
the number you have assigned to your switcher (usually 1-9, or "0" for one of the
four inputs on the projector). The second digit represents the switcher's slot number
(1-9). For example:
Input
NOTES: 1) Although you don't need to use the input key unless a switcher is
connected to the projector, you can also use
the projector itself: use
switcher), then
in combination with higher numbers is an invalid entry. 2) See 3.5, Using
Channels and Inputs for a detailed explanation of inputs.
NOTE:
Input
key behavior during a presentation depends on whether or not the
Display Channel List option is selected in the Menu Preferences menu. You can
choose to have on-screen feedback when you press
the desired source location "blind", i.e., without on-screen feedback. See Menu
Preferences later in this section.
Channel
Chan
Press
Chan
to select a specific source setup (channel) defined and stored in projector
memory. Once you enter a 2-digit channel number (or, if there is a list displayed,
highlight it and press
according to the numerous setup parameters defined for that channel.
Chan
NOTE:
key behavior during a presentation depends on whether or not the
Display Channel List option is selected in the Menu Preferences menu. You can
choose to use a scrollable list of channels when you press
enter the desired channel number "blind", i.e., without on-screen feedback. See
Menu Preferences later in this section.
Standby
Stby*
Press
Stby*
and hold for approximately 1 second to blank all display output while
keeping the projector in a warmed-up and ready state. Or quickly press and release
Stby*
and follow immediately by
toggle (useful if you are unsure of the present status). Note that the lamp and
electronics remain ON in standby mode, even though the image turns to black and
most functions are disabled. To leave standby press and hold
OFF
). Or simply press
Menu
Menu
Press
Menu
to display the Main menu. A list of several options appears for access to
specific functions, such as Channel Setup or Image Settings. Press
remove all menus and return to presentation level.
Input
.
= display data from switcher 1, slot 2.
as the first digit (representing the projector as the
,
,
, or
as the second digit (the desired input slot number).
Enter
), the display will automatically change and update
ON
or
Exit
or
Menu
.
INPUT 4
on the projector (S-Video). This
Input
to access the four input "slots" on
Input
, or you may prefer to enter
Chan
, or you may prefer to
OFF
if you want to guarantee the correct
Stby*
again (or use
Stby*
Menu
again to
Advertisement
Table of Contents
