Lens Control - Christie DLV1280 DX User Manual

OPERATION
3-26
DLV1280 DX User's Manual
V-Position
(
SHORT CUT:
Press Position
This option moves the image up or down.
NOTE: The value shown represents where the approximate center of the image lies in
relation to the total number of pixels available vertically. This varies widely
according to the signal—watch the image while adjusting.

Lens Control

Not in this projector.
Blanking: Top, Bottom, Left or Right
This submenu blanks (turns to black) the top, bottom,
left, or right edge of the image so that any unwanted
information is cropped from view. For example, when
displaying native size video you may want to blank out
a few of the top lines.
PLL Loop Gain
This control changes the relative offset to the default gain. The default PLL (Phase
Lock Loop) Gain setting of 10 is set automatically with a Pixel Tracking adjustment
and is correct in most cases. In rare instances, such as if your image exhibits tearing
or "flag-waving", increase the PLL loop gain setting as necessary. Or, if your image
is unstable and "breaks up", this may indicate that the PLL loop gain setting is either
too high or too low. PLL Loop Gain affects the current channel only.
Keystone
Not available in this projector.
Plug & Display (EDID)
NOTE: Requires optional DVI Input Module. Disabled for all other inputs.
By default, the Plug & Display option detects an incoming digital flat panel video
signal and displays it in the native resolution of your
projector. If you have additional daisy-chained projectors,
they will display in this resolution as well. If you want to
use a different resolution (for example, your graphics card
may not support the current resolution), select a different
Plug & Play setting from the list.
Tiling Setup
See 3.10, Using Multiple Projectors (Tiling Setup section).
and adjust the bottom slidebar.)