Christie DLV1280 DX User Manual page 97

MAINTENANCE
Lamp and Filter
Replacement
Power Cord
and Attachments
Ventilation
4-2
DLV1280 DX User's Manual
'
Never attempt to remove the lamp housing directly after use.
The lamp is under increased pressure when hot and may
explode, causing personal injury and/or property damage.
The arc lamp operates at a very high temperature and pressure.
Failure to allow the lamp to sufficiently cool prior to handling could
result in an explosion causing personal injury and/or property
damage. After turning the projector off it is recommended that you
wait at least five minutes before unplugging it. This provides
enough time for the internal lamp cooling fans to cool the lamp and to automatically
shut off. Cool completely before handling.
Use only lamps supplied by the manufacturer of the projector.
FILTER:
Replace the side filter every 1000 hours or sooner. If this filter is not
replaced, air flow may become restricted and cause the projector to overheat.
See 4.4, Replacing the Lamp and Filter for the complete replacement procedure.
Use only filters supplied by the manufacturer of the projector.
'
Only use attachments or accessories recommended by the manufacturer, such as the
specific power cord supplied. Use of other attachments or accessories may result in
the risk of fire, shock and/or personal injury.
Use only the AC power cord supplied. Do not attempt operation
if the AC supply and cord are not within the specified voltage
Do not allow anything to rest on the power cord. Locate the projector where the cord
cannot be abused by persons walking on it or objects rolling over it.
Operate the projector at the specified voltage only. Do not overload power outlets
and extension cords as this can result in fire or shock hazards.
The projector is equipped with a three wire plug having a third (grounding) pin. This
is a safety feature. If you are unable to insert the plug into the outlet, contact an
electrician to have the outlet replaced. Do not defeat the safety purpose of the
grounding-type plug.
'
Before unplugging the power cord, make sure the internal lamp
cooling fans have shut off—these fans automatically shut off when
the projector has adequately cooled down.
Slots and openings in the projector provide ventilation. To ensure
reliable operation of the projector and to prevent overheating, these openings must
never be blocked or covered. The projector should never be placed near or over a
radiator or heat register. The projector should not be placed in an enclosure unless
proper ventilation is provided.
WARNING
Allow to cool completely.
WARNING
WARNING
WARNING
and power range. See Section 5.