Christie DLV1280 DX User Manual page 85

OPERATION
3-52
DLV1280 DX User's Manual
Step 2: ESTABLISH STARTING POINT FOR COLOR ADJUSTMENT
2a) ENABLE PRIMARY COLOR ADJUSTMENT:
menu ( Menu ), enter a checkmark in the Use Primary Color Adjustment
checkbox so that primary color controls can be adjusted and applied to the
image. See Figure 3.29.
Figure 3.29. Enabling Primary Color Adjustment
Note also that enabling Use Primary Color Adjustment also sets Gamma to its
default—no other setting of Gamma is possible with adjusted primary colors.
If at any time you decide not to use or apply the Adjust Primary Colors (CSC)
feature, delete its checkmark—this disables Red Primary, Green Primary and
Blue Primary controls (and they will appear "grayed out" in the menu). In
addition, full normal adjustment of Gamma is regained.
2b) SELECT A "USER" COLOR TEMPERATURE ("User 1" RECOMMENDED):
Adjust Primary Color (CSC) menu, select a "User" color temperature that you
will be defining through your adjustment of primary colors on each projector.
Choose any of the four User
choices, but note that User 1
is the default color
temperature applied if you
add a new source in the
future while Primary Color
Adjustment is activated
(instead of the usual default
of 6500K applied when
Primary Color Adjustment is
not enabled). As in any color
temperature menu, white
levels for preset color
temperatures cannot be
changed. See Figure 3.30.
2c) SET 90% WHITE LEVELS STARTING POINTS:
(CSC) menu, set all White Levels to 90% (note: appears as 90.2 in the menu).
See Figure 3.30.
In the Adjust Primary Color (CSC)
Figure 3.30. Start With a "User"
Temperature and 90% White Levels
NOTE: "USER 1" RECOMMENDED
In the Adjust Primary Color
In the