Christie DLV1280 DX User Manual page 27

Table of Contents

INSTALLATION AND SETUP

2-24

DLV1280 DX User's Manual

For either type of network, continue connecting projectors in this manner until

you've reached the last projector in the chain, so that only the last projector has an

RS-232 OUT

RS-422 PORT

empty

(or

Note that communication parameters such as baud rate must be set to match the

particular controlling device before connecting as a network—refer to the

documentation that came with your controlling device in order to determine the

proper baud rate. See 3.7, Configuring System Parameters if you need help changing the

projector baud rate from its default of 19200.

NOTES: 1) To avoid damage, connect only properly wired serial communication

cables. See Appendix D for details. 2) It is recommended that each RS-232

communication cable be no more than 25 feet in length. Use high quality cables.

, if applicable). See examples below.

Figure 2.26. Assorted Networks

Table of Contents