Setup Procedure; Tf Series Settings; Tio1608-D Settings - Yamaha Tio1608-D Setup Manual

Setup Procedure

TF Series settings

To begin, enable the Quick Config and the HA Control functions on the TF
Series. The Quick Config function can automatically patch the Dante
network between the TF series and Tio1608-D. Enabling HA Control will
allow you to operate the head amp of the Tio1608-D from the TF Series.
Open the "SLOT SETUP" screen, and make sure that both the Quick Config
and the HA Control buttons are ON (the default setting is "ON").
Note:
 Up to two TF Series consoles can be connected to a single Tio1608-D at
once. Make sure only up to two TF Series consoles are connected to the
same network. In addition, only one console among them should have
HA Control enabled.
 When "with OUTPUT" on the Quick Config function is turned OFF (the
default is ON), only the input from the Tio1608-D to the TF Series will
be patched automatically, and the output from the TF Series will not be
patched. When you wish to freely patch only the output channels, turn
this option OFF.
 When two TF Series are connected to a single Tio1608-D and the Quick
Config "with OUTPUT" options are both ON, the "with OUTPUT" option
on the TF Series that is connected afterwards will automatically be set
to OFF. Set "with OUTPUT" on only one of the TF Series to ON
beforehand as appropriate.

Tio1608-D settings

Turn the Quick Config switch on the Tio1608-D front panel to ON. By
doing this, automatic Dante patching between the TF Series and Tio1608-
D will be made. Use the front panel ID switches to assign an unique ID (1
to 3) to each unit. The I/O patches are predetermined for each ID when
using the Quick Config function. After changing the Quick Config or ID
settings, reboot the Tio1608-D.
4
TF Series & Tio1608-D
www.yamahaproaudio.com