Korg microX Operation Manual Page 65

Hide thumbs
The "Status" setting is located in the COMBI 2:
Ed–Track Param, MIDI page, and the "Program
Change" setting is located in the COMBI 3: Ed–
MIDI Filter1, -1 page.
The result of receiving a program change on the
global MIDI channel will depend on the GLOBAL
1: MIDI "Combi (Combination Change)" setting.
Using Controllers
Just as in Program mode, you can use controllers
such as the joystick, OCTAVE [†][π] buttons, and
REALTIME CONTROLS [1]–[4] to add a broad
range of expression to your playing in Combina-
tion mode.
These controls let you modify the tone, pitch, vol-
ume, effects, etc. in realtime while you play.
For more details, see "Using Controllers" (☞p.59).
REALTIME CONTROLS [1], [2], [3], and [4] will
also function as external controls.
Sending MIDI information from the
various controllers
When you select a combination on microX, a MIDI
program change for the selected combination
number will be transmitted on the global MIDI
channel. At the same time, bank select, program
change, and volume (CC#7) messages will be
transmitted on the MIDI channel specified for
each timbre that is set to "Status" of EXT or EX2.
However, these messages will not be transmitted
for timbres that are set to the same MIDI channel
as the global MIDI channel. In this case, EX2 tim-
bres will show the "Program Select" Bank as "–",
and will transmit the bank number that was speci-
fied in "Bank (EX2) MSB"and "Bank (EX2) LSB"
MIDI messages transmitted when you operate
microX are transmitted on the global MIDI chan-
nel. At the same time, timbres whose "Status" is
EXT or EX2 will transmit the same messages on
their own MIDI channel.
For details on the MIDI messages transmitted
when you operate an microX controller, and on the
AMS (Alternate Modulation Source) and DMS
(Dynamic Modulation Source) corresponding to
the MIDI messages, see "MIDI transmission when
the X50/microX's controllers are operated" (☞PG
Using Controllers


   Also See for Korg microX

   Related Manuals for Korg microX

Comments to this Manuals

Symbols: 0
Latest comments: