Korg microX Operation Manual: Assigning A Name (rename)

Synthesizer/controller.
Hide thumbs
Other functions

Assigning a name (Rename)

You can modify the name of any program, combi-
nation, multi set, category, arpeggio pattern, etc.
The following table shows the items that you can
rename, and the corresponding page.
Item to rename
Program name
Combination name
Multi set name
Track name
Drum kit name
Arpeggio pattern name
External control set
name
Program category name
Combination category
name
1. Use the ClickPoint to select the text button (
and press the center to open the text dialog box.
See the table above for the appropriate page.
Note: In a utility menu command, select the text
button (
) in the dialog box that appears.
In GLOBAL 3, select the text button (
page.
The text dialog box will appear.
For example to enter the text shown in the
illustration, you would proceed as follows.
2. Use the ClickPoint [√][®][π][†] to select
"Clear."
All text will be erased from the text box.
3. Enter "A".
Use the [VALUE] dial to select "A".
Press the ClickPoint [®]. The cursor will move.
114
Page
PROG 0...9 Utility: Write Program
COMBI 0...9 Utility: Write
Combination
MULTI 0-1 Utility: Rename Track
MULTI 0...9 Utility: Write Multi
GLOBAL 4 Utility: Rename Drum
Kit
GLOBAL 5 Utility: Rename
Arpeggio Pattern
GLOBAL 5 Utility: Rename
Ext.Control Setup
GLOBAL 3: TEXT
GLOBAL 3: TEXT
) in the
• You can enter text using just the ClickPoint.
When you press the ClickPoint center, the
square-framed cursor in the text box will
change.
Use the ClickPoint [√][®][π][†] to select a
character. Press the center once again to finalize
the selection.
Use the ClickPoint [®] to select the next
character, and enter it in the same way.
• The function buttons shown in the lower line
perform the following operations. Use the
ClickPoint [√][®][π][†] to select a function,
and press the center to execute it.
Clear: Erase all text.
Del (Delete): Delete the character at the cursor
location.
Ins (Insert): Insert a space at the cursor
location.
Cap. (Capital): Switch between uppercase and
lowercase letters.
4. Enter the remaining characters as described in
step 3.
),
5. Press the [MENU/OK] button.
If you opened the text dialog box from the
utility dialog box in step 1, you will return to
the previous dialog box. In that dialog box,
press the [MENU/OK] button (twice) to
execute the Rename operation.
If you opened the text dialog box from the
GLOBAL 3 page in step 1, the Rename
operation will be executed.

Advertising

   Also See for Korg microX

   Related Manuals for Korg microX

Comments to this Manuals

Symbols: 0
Latest comments: