Table of Contents
Advertisement
Administration: Discovery
Configuring CDP
STEP 3
STEP 1
STEP 2
STEP 3
Cisco 220 Series Smart Plus Switches Administration Guide Release 1.0.0.x
•
Syslog Duplex Mismatch—Check Enable to send a SYSLOG message
when duplex information is mismatched. This means that the duplex
information in the incoming frame does not match what the local device is
advertising.
Click Apply. The CDP properties are defined, and the Running Configuration is
updated.
Configuring CDP Port Settings
Use the Port Settings page to enable or disable CDP per port. Notifications can
also be triggered when there are conflicts with CDP neighbors. The conflict can be
Voice VLAN data, Native VLAN, or Duplex.
To define the CDP port settings:
Click Administration > Discovery CDP > Port Settings.
The following CDP information for each port is displayed:
•
CDP Status—CDP publishing option for the port.
•
Reporting Conflicts with CDP Neighbors—Displays the status of the
reporting options (Voice VLAN/Native VLAN/Duplex) that are enabled/
disabled on the Edit page.
•
No. of Neighbors—Number of neighbors detected.
Select a port and click Edit.
Enter the following information:
•
Interface—Select the port to be defined.
•
CDP Status—Check Enable to enable the CDP publishing option for the
port.
The next three fields are operational when the switch has been set up
NOTE
to send traps to the management station.
•
Syslog Voice VLAN Mismatch—Check Enable to send a SYSLOG message
when a voice VLAN mismatch is detected. This means that the voice VLAN
information in the incoming frame does not match what the local device is
advertising.
8
94
Advertisement
Table of Contents
