Administration: General Information
Viewing System Summary
Cisco 220 Series Smart Plus Switches Administration Guide Release 1.0.0.x
•
Firmware MD5 Checksum (Non-active Image)—MD5 checksum of the
non-active firmware image.
•
Boot Version—Version number of the switch's bootloader.
•
Locale—Locale of the first language. (This is always en-US.)
•
Language Version—Language package version of the first language.
•
Language MD5 Checksum—MD5 checksum of the first language.
•
Locale—Locale of the second language.
•
Language Version—Language package version of the second language.
•
Language MD5 Checksum—MD5 checksum of the second language.
TCP/UDP Services Status
•
HTTP Service—Shows whether the HTTP service is enabled or disabled.
•
HTTPS Service—Shows whether the HTTPS service is enabled or
disabled.
•
SNMP Service—Shows whether the SNMP service is enabled or disabled.
•
Telnet Service—Shows whether the Telnet service is enabled or disabled.
•
SSH Service—Shows whether the SSH service is enabled or disabled.
You can click Edit to go to the Security > TCP/UDP Services page to
NOTE
enable or disable these services on the switch.
PoE Power Information (only applicable for the PoE models)
•
Maximum Available PoE Power (W)—Maximum available power that can
be delivered by the PoE ports.
•
Total PoE Power Consumption (W)—Total PoE power delivered to the
connected PoE devices.
•
PoE Power Mode—Port Limit or Class Limit.
You can click Detail to go to the Port Management > PoE > PoE
NOTE
Properties page to see more details about the PoE settings.
Other Summary Information
•
Serial Number—Serial number.
•
PID VID—Part number and version ID.
5
59