Creating Vlans - Cisco 220 Series Smart Plus Administration Manual

Managing VLANs

Creating VLANs

STEP 3
Creating VLANs
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
Cisco 220 Series Smart Plus Switches Administration Guide Release 1.0.0.x
Click Apply. The default VLAN is changed, and the Running Configuration is
updated.
You can create a VLAN, but this has no effect until the VLAN is attached to at least
one port, either manually or dynamically. Ports must always belong to one or more
VLANs.
Each VLAN must be configured with a unique VID (VLAN ID) with a value from 1 to
4094. The switch reserves VID 4095 as the Discard VLAN. All packets classified to
the Discard VLAN are discarded at ingress, and are never forwarded to a port.
To create a VLAN:
Click VLAN Management > Create VLAN.
The VLAN Table displays the following fields for all VLANs:
• VLAN ID—Identifier of the VLAN.
• VLAN Name—The name of the VLAN.
• Type—The type of VLAN. The options are:
- Dynamic—The VLAN was dynamically created through Generic VLAN
Registration Protocol (GVRP).
- Static—The VLAN is user-defined.
- Default—The VLAN is the default VLAN.
Click Add to add a new VLAN or select an existing VLAN and click Edit to modify
the VLAN parameters.
To create a single VLAN, select the VLAN radio button, enter the VLAN ID (VID),
and optionally the VLAN Name.
To create a range of VLANs, select the Range radio button, and specify the range
of VLANs to be created in the VLAN Range area.
Click Apply. The VLAN(s) is created, and the Running Configuration is updated.
11
126