Table of Contents
Advertisement
Multicast Forwarding
Configuring Forward All Multicast
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
Configuring Forward All Multicast
NOTE
Cisco 220 Series Smart Plus Switches Administration Guide Release 1.0.0.x
To define Multicastrouter ports:
Click Multicast > Multicast Router Port.
Enter some or all of following query filter criteria:
•
VLAN ID equals to—Select the VLAN ID for the router ports that are
described.
•
IP Version equals to—Select the IP version that the Multicast router
supports.
•
Interface Type equals to—Select whether to display ports or LAGs.
Click Go. The interfaces matching the query criteria are displayed.
For each interface, select its association type. The options are as follows:
•
Static—The port is statically configured as a Multicastrouter port.
•
Dynamic—The port is dynamically configured as a Multicastrouter port by a
MLD/IGMP query. To enable dynamic learning of Multicastrouter ports, go to
the IGMP Snooping and MLD Snooping pages.
•
Forbidden—This port is not to be configured as a Multicastrouter port, even
if IGMP or MLD queries are received on this port.
•
None—The port is not currently a Multicastrouter port.
Click Apply. The Running Configuration is updated.
The Forward All page enables and displays the configuration of the ports and/or
LAGs that are to receive Multicast streams from a specific VLAN.
You can statically configure a port to Forward All, if the devices connecting to the
port do not support IGMP and/or MLD.
The configuration affects only the ports that are members of the selected VLAN.
14
168
Advertisement
Table of Contents
