Table of Contents
Advertisement
SNMP
Configuring SNMP Notification Recipients
STEP 4
STEP 1
STEP 2
STEP 3
Cisco 220 Series Smart Plus Switches Administration Guide Release 1.0.0.x
•
Notification Version—Select the trap SNMP version. Either SNMPv1 or
SNMPv2 may be used as the version of traps, with only a single version
enabled at a single time.
Click Apply. The SNMPv1,2 notification recipient is defined, and the Running
Configuration is updated.
Configuring SNMPv3 Notification Recipients
To define a recipient in SNMPv3:
Click SNMP > Notification Recipients SNMPv3.
Click Add to create an SNMPv3 notification recipient.
Enter the following information:
•
Server Definition—Select either By IP Address or By Name to define the
notification recipient.
•
IP Version—Select either Version 4 or Version 6 if the notification recipient
is identified by IP address.
•
Receiver IP—Enter the IP address or host name of where the traps are sent.
•
UDP Port—Enter the UDP port used for notifications on the recipient device.
•
Notification Type—Select whether to send Traps or Informs. If both are
required, two recipients must be created.
•
Timeout—Enter the number of seconds that the switch waits before re-
sending informs. The default is 15 seconds.
•
Retries—Enter the number of times that the switch resends an inform
request. The default is 3.
•
User Name—Select the user to whom SNMP notifications are sent. In order
to receive notifications, this user must be defined on the Users page, and its
Engine ID must be remote.
•
Security Level—Select how much authentication is applied to the packet.
19
277
Advertisement
Table of Contents
