Workflow To Configure Vlans - Cisco 220 Series Smart Plus Administration Manual

Managing VLANs
VLANs
Cisco 220 Series Smart Plus Switches Administration Guide Release 1.0.0.x
Adjacent VLAN-aware devices exchange VLAN information with each other by
using Generic VLAN Registration Protocol (GVRP). As a result, VLAN information is
propagated through a bridged network. VLANs on a device can be created
statically or dynamically, based on the GVRP information exchanged by devices. A
VLAN can be static or dynamic (from GVRP), but not both. For more information
about GVRP, refer to the
Some VLANs can have additional roles, including:
• Voice VLAN—For more information refer to the
section.
• Guest VLAN—Set on the Edit VLAN Authentication page.
• Default VLAN—For more information refer to the
VLAN section.
• Management VLAN (in Layer 2-system-mode systems)—For more
information refer to the

Workflow to Configure VLANs

Workflow to Configure VLANs
To configure VLANs:
• If required, change the default VLAN as described in the
Default VLAN
• Create the required VLANs as described in the
• Set the desired per port VLAN-related configuration as described in the
Configuring VLAN Interface Settings
• Assign interfaces to VLANs as described in the
section.
• View the current VLAN port membership for all interfaces as described in
the Viewing VLAN Membership
• Enable GVRP globally as well as on each port as described in the
Configuring GVRP
• Configure the voice VLAN parameters as described in the
Voice VLAN section.
Configuring GVRP
IP Addressing
section.
section.
section.
section.
Configuring Voice VLAN
Configuring Default
section.
Configuring
Creating VLANs
section.
Configuring Port to VLAN
11
section.
Configuring
124