Mapping Queue To Dscp - Cisco 220 Series Smart Plus Administration Manual

Quality of Service
Workflow to Configure QoS Settings
STEP 3
STEP 4
STEP 1
STEP 2
STEP 3
STEP 4
STEP 1
STEP 2
STEP 3
STEP 4
Cisco 220 Series Smart Plus Switches Administration Guide Release 1.0.0.x
Click Apply. The Running Configuration is updated.
Click Restore Defaults to restore Queues to IP precedence mappings to their
factory default settings.

Mapping Queue to DSCP

Use the Queues to DSCP page to remark DSCP value for egress traffic from each
queue.
To map queues to DSCP values:
Click Quality of Service > General > Queues to DSCP.
For each output queue select the DSCP value to which egress traffic from the
queue is remarked.
Click Apply. The Running Configuration file is updated.
Click Restore Defaults to restore the Queue to DSCP mappings to their factory
default settings.
Configuring Interface Remark
Use the Remark Interface Settings page to remark the CoS/802. 1 p priority, IP
precedence, and/or DSCP value for egress traffic on a port. The CoS/802/1p
priority and IP precendence, or the CoS/802/1p priority and DSCP value can be
remarked simultaneously, but the DSCP value and IP precendence cannot be
remarked simultaneously.
To remark egress traffic on an interface:
Click Quality of Service > General > Remark Interface Settings.
Select an interface type (Port or LAG), and click Go.
Select a port or LAG, and click Edit.
Enter the following information for the selected port or LAG:
• Remark CoS—Check Enable to remark the CoS/802. 1 p priority for egress
traffic on this port or LAG.
18
248