Table of Contents
Advertisement
Multicast Forwarding
Configuring Multicast Filtering
STEP 5
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
Cisco 220 Series Smart Plus Switches Administration Guide Release 1.0.0.x
•
End Multicast Address—Enter the ending Multicast group address.
•
Action—Denies or permits Multicast frames when the join group matches
the profile IP group range.
Click Apply. The Running Configuration is updated.
Configuring Interface Filter Settings
To assign the specified Multicast filter profile to an interface to deny or permit the
Multicast group when the join group matches the filter profile:
Click Multicast > Multicast Filtering > Filter Settings.
Select the IP version and port type (Port and LAG), and click Go.
Select an interface and click Edit.
Enter the following information:
•
Interface—Select an interface.
•
Filter—Check Enable to enable filtering Multicast traffic on this interface, or
uncheck to disable this feature on the interface.
•
Filter Profile Index—Select a specified Multicast filter profile to be applied.
The Multicast filter settings defined in the profile are applied to the interface.
Click Apply. The Running Configuration is updated.
14
171
Advertisement
Table of Contents
