Configuring Qos Properties - Cisco 220 Series Smart Plus Administration Manual

Quality of Service
Workflow to Configure QoS Settings
STEP 8
STEP 9
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
Cisco 220 Series Smart Plus Switches Administration Guide Release 1.0.0.x
• Set egress shaping per queue as descirbed in the
Shaping per Queue
• Set VLAN ingress rate limit as descirbed in the
Limit section.
Configure the selected mode by performing one of the following:
• Configure QoS basic mode as described in the
Mode section.
• Configure QoS advanced mode as described in the
Advanced Mode
Activate the TCP congestion avoidance algorithm as described in the
TCP Congestion Avoidance

Configuring QoS Properties

Use the QoS Properties page to configure the QoS mode for the switch. In
addition, the default CoS priority for each interface can be defined.
To select the QoS mode and define the default CoS priority for each interface:
Click Quality of Service > General > QoS Properties.
Select the QoS mode (basic, advanced, or disabled) that will be active on the
switch.
Click Apply. The QoS mode is defined, and the Running Configuration is updated.
The Interface CoS Configuration Table displays the default CoS value for each
interface. To modify the interface's default CoS value, select the desired interface
and click Edit.
Enter the following information:
• Interface—Select the interface to be configured.
• Default CoS—Select the default CoS value to be assigned for incoming
packets (that do not have a VLAN tag). The range is 0 to 7.
The default CoS value is applicable only if the switch is in QoS basic mode
and CoS/802. 1 p is the trusted mode.
section.
section.
section.
18
Configuring Egress
Configuring VLAN Rate
Configuring QoS Basic
Configuring QoS
Configuring
242