CYCLE PARTS
5.7.8.
REFITTING THE FINAL DRIVE UNIT BEARINGS
If fitted:
•
Remove the final drive unit bearings.
Work on the left-hand side:
NOTE
Use
the
- aprilia part# 8140180 (bearing extractor)
•
Insert the right bearing (6) completely, using the drift.
NOTE The right bearing must be inserted until it is fully
home against the abutment (Y).
•
Fit the inner spacer (5).
•
Insert the left bearing (4), using the drift.
NOTE Complete insertion of the left bearing (4) will couple
the following components:
-
right bearing (6);
-
inner spacer (5);
-
left bearing (4).
•
Fit the circlip (3).
NOTE The circlip (3) is fitted only on the left side of the final
drive unit.
•
Fit a new seal (2).
•
Fit the left spacer (1) with the larger diameter facing
the vehicle exterior.
Work on the right-hand side:
•
Fit the right spacer (7) with the larger diameter facing
the vehicle exterior.
5 - 94
special
tool
OPT:
TUONO 1000