CYCLE PARTS
5.8.
FRONT BRAKE
5.8.1.
CHANGING THE PADS
TIGHTENING TORQUES
Brake calliper screws (1)
WARNING
This vehicle is equipped with a double-disc
front brake system (right and left side).
Always replace all the pads of both front brake
callipers.
Replacing the pads of only one front calliper
would compromise the stability and safety of
the vehicle, potentially resulting in danger for
people, things and the vehicle itself.
NOTE The following procedure refers to a single calliper but
applies to both.
•
Loosen and remove the two brake calliper fixing
screws (1).
•
Remove the front brake calliper from the disc.
•
Press on the safety spring (2) and simultaneously slide
the pin out (3).
•
Remove the safety spring (2).
5 - 100
50 Nm (5 kgm)
TUONO 1000