Removing The Swingarm Bearings - APRILIA TUONO 1000 Workshop Manual

CYCLE PARTS
5.5.3.

REMOVING THE SWINGARM BEARINGS

•
Remove the swingarm.
•
Clean the two sides of the bearing housings with a
cloth.
•
Remove the bushing (1).
•
Remove the seal (2).
•
Remove the seal (3).
•
Remove the circlip (4).
NOTE Use the
- aprilia part# 8140180 (bearing extractor)
•
Remove the two bearings (5) and the roller bearing (6)
with the extractor.
WARNING
After removing the bearings, check to see if
they should be replaced.
•
Remove the inner spacer (7) and set aside the two O-
rings (8).
• Remove the inner spacer (9).
•
Remove the gaskets (10).
•
Remove the two roller bearings with an extractor (11).
WARNING
After removing the bearings, check to see if
they should be replaced.
•
Clean the bearing housing thoroughly.
NOTE Wash all components with clean detergent.
WARNING
When reassembling, to insert the bearings, use
a drift with the same diameter as the outer ring
of the bearing.
Do not hammer the rollers and/or the inner ring.
5 - 66
special tool OPT:
TUONO 1000