Refitting The Front Wheel Bearings - APRILIA TUONO 1000 Workshop Manual

CYCLE PARTS
5.6.5.

REFITTING THE FRONT WHEEL BEARINGS

If fitted:
•
Remove the front wheel bearings.
Work on the right-hand side of the wheel:
NOTE Use the
- aprilia part# 8140180 (bearing extractor)
•
Insert the right bearing (5) completely, using the drift.
NOTE The bearing must be inserted until it is fully home
against the abutment (Y).
•
Fit the circlip (3).
NOTE The circlip (3) is fitted only on the right side of the
wheel.
Work on the left-hand side of the wheel:
• Fit the spacer (4).
NOTE Use the
- aprilia part# 8140180 (bearing extractor)
•
Insert the left bearing (6), using the drift.
NOTE Complete insertion of the left bearing (6) will couple
the following components:
- right bearing (5);
- spacer (4);
- left bearing (6).
WARNING
Once it is home against the right bearing (5) do
not push further to avoid forcing the circlip (3).
NOTE Once the left bearing has been fitted (6), check that
the following components are coaxial:
- right bearing (5);
- spacer (4);
- left bearing (6).
•
Fit a new seal (2).
Work on the right-hand side of the wheel:
•
Fit a new seal (2).
•
Fit the spacer (1) with the larger diameter facing the
vehicle exterior.
5 - 78
special tool
special tool
OPT:
OPT:
TUONO 1000