TUONO 1000
5.5.2.
CHECKING THE COMPONENTS
WARNING
Check
that
all
especially those listed below.
SWINGARM BEARINGS
Perform the check with the bearings fitted on the swingarm.
ROTATION CHECK
•
Manually turn the inner ring of each bearing. Rotation
must be continuous, smooth and silent.
If one or both bearings do not meet the specifications:
•
replace both swingarm bearings.
DANGER
Always replace both bearings.
Always replace bearings with bearings of the
same type.
RADIAL AND AXIAL PLAY CHECK
•
Check radial and axial play.
Axial play: minimum axial play is accepted.
Radial play: none.
If one or both bearings do not meet the specifications:
•
replace both swingarm bearings.
DANGER
Always replace both bearings.
Always replace bearings with bearings of the
same type.
SWINGARM SEALS
•
Check that all seals are intact; replace them if they are
damaged or worn.
DANGER
Always replace both seals.
Always replace seals with seals of the same
type.
SWINGARM PIVOT
•
Using a dial gauge, check the eccentricity of the
swingarm pivot (1). If eccentricity exceeds the specified
limits, replace the swingarm pivot (1).
Maximum eccentricity: 0.3 mm (0.012 in).
components
are
intact,
CYCLE PARTS
5 - 65