APRILIA TUONO 1000 Workshop Manual page 61

TUONO 1000
SCREEN DESCRIPTION
Initialisation fault
Lambda control
Engine variant
Injectors per cylinder
Knock sensor
Boost adjustment
Lambda sensor
Water injection
Idling mot. fitted
Purge valve
Electronic reverse
Electric starting
Initialised ECU
ENABLE
DEVICES
Delete errors
Fuel pump
Lambda sensor heating
Fan
UNIT
APPROXIMATE
OF
VALUES
MEASURE
no/engine speed>0/
speed>0/ stepper error/ throttle
position / battery voltage/ water
temperature / stepper motor off
initializ./Wait.after
start/Ric.st.lambda/Att.after
ric/Dis.for rid./Dis. for err/Att.after
int/Lambda act/Saturat.
1/2 -
1cyl -
No -
No -
Yes -
No -
Yes -
yes/no -
No -
Yes -
yes/no
- -
- -
- -
- -
NOTE
Possible factors that may have caused
unsuccessful Throttle position learning
vehicle or Initialisation, in this order: Engine
speed>0/Vehicle
motor error/Incorrect
position/Incorrect
/Water temperature /Stepper motor
disconnected
Current lambda sensor conditions
1 if standard mapping is active, 2 if
Racing mapping is active -necessary
when using non-approved
pipes
ECU status that cannot be changed:
should read "1cyl"
ECU status that cannot be changed:
should read "no"
ECU status that cannot be changed:
should read "no"
ECU status that can be changed with
password authority only; should usually
read "YES", i.e.
available
ECU status that cannot be changed:
should read "no"
ECU status that can be changed with
password authority only; should usually
read "YES", i.e. stepper motor available
Parameter not
purge valve)
ECU status that cannot be changed:
should read "no"
ECU status that cannot be changed:
should read "yes"
If status is "yes", it indicates that the
parameter "Initialised
activated. If the ECU needs replacing,
this parameter should be activated or
the engine rpm will be limited
Press ENTER to switch error status
from memorised (MEM)
(STO). The next
connected to the ECU, the deleted
errors (STO) will no longer be displayed
The device is activated: if not correctly
activated, the tester will NOT show
failed activation
necessary to check the detected faults
page
The device is activated: if not correctly
activated, the tester will NOT show
failed activation
necessary to check the detected faults
page
The device is activated: if not correctly
activated, the tester will NOT show
failed activation
necessary to check the detected faults
page
FUEL SYSTEM
speed>0/stepper
throttle
battery voltage
exhaust
lambda sensor
active (mechanical
ECU" was
to deleted
time Axone is
immediately; it is
immediately; it is
immediately; it is
3 - 11