Nac Hi-Moiton II Quick Manual page 59

No. Name
1 VD IN
2 VD IN RET
3 VD OUT
4 VD OUT RET
5 TRIG IN
6 TRIG IN RET
・
・
7 AUX Connector
The complex connector controls RETURN and TALLY signals.
・
・
・
・
No. Name
1 RET 1
2 RET 2
3 G TALLY
4 R TALLY
5 N.C
6 N.C
7 N.C
8 N.C
9 GND
10 GND
・
・
8-9 DC IN 1, 2 Connector
+12V Input connector for Camera Head. Power can be supplied to the Camera Head via DC IN 1, DC IN 2 or
AC/DC Power Supply inside the Camera Head through optical fiber cable. When power is supplied by all the
connectors, the Camera Head is run by the highest voltage input.
No. Name
L +12V
N +12V RET
FG N.C
・
・
・
10-11 MIC 1, 2 Connector
Connect an external microphone. Audio signal input into the connector is output from MIC OUT on the rear of
CCU and also is embedded in HD-SDI signal when selected with the CCU menu (LIVE audio is embedded).
No. Name
1 SHIELD
2 MIC (HOT)
Direction
Input for External Sync signal
IN
3.3VCMOS / Low active
GND Return
Output of Frame Sync signal
OUT
3.3VCMOS / Low active
GND Return
IN Make contact or 3.3VCMOS / Falling edge
GND Return
Connector : HR10G-7R-6S(73) (HIROSE)
Applicable Plug : HR10A-7R-6P(73) or HR10A-7R-6PC(73) (HIROSE)
: Display RETURN video selected by "RET 1" on VF
RET 1 IN
: Display RETURN video selected by "RET 2" on VF
RET 2 IN
G TALLY OUT : Show status of G TALLY
R TALLY OUT : Show status of R TALLY
Direction
IN Open Drain
IN Open Drain
OUT Open Drain
OUT Open Drain
GND
GND
Connector : HR10G-10R-10S(71) (HIROSE)
Applicable Plug : HR10A-10R-10P(73) or HR10A-10R-10PC(73) (HIROSE) OUT
Direction Function & In/Out Level
IN +11V to +16V
GND Return
Connector : NAC3MPA-1 (NEUTRIK)
Applicable Plug : NAC3FCA (NEUTRIK)
Input voltage : DC+11V to DC+17V
Direction
Phantom power
600 ohm balance in.
IN AB power
Phantom power
Function & In/Out Level
Function & In/Out Level
Function & In/Out Level
: DC 48V Return
: DC 12V
: DC 48V
59
Note
Note
Note
DC IN 1, DC 2 IN and internal
AC/DC power unit output are
connected by ORing.
Note