Precautions When Using Shed-Hdx Systems Of Telecast Fiber Systems, Inc - Nac Hi-Moiton II Quick Manual

13 Precautions when using SHED-HDX. Systems of Telecast Fiber Systems, Inc.
13.1 Setup
A Hi-MotionII supports SHED-HDX. Systems of Telecast Fiber Systems, Inc. for IKEGAMI system.
B Set up and connect all the necessary cables according to its User Manual.
C Open the front panel of CCU and find AUX board. There are two red switches in the front part of AUX
board and set the one of the switch at upper part as "SINGLE MODE ON".
13.2 Order turn on the power
When using the SHED-HDX. Systems, you can turn on the power of either the CCU or the
Camera Head first but check the following notes.
・ CCU :
Turn ON both MAIN POWER switch and HEAD POWER switch on the front panel of CCU. As well as the
process without the SHED-HDX. Systems, HEAD POWER switch must be turned ON. When the switch is OFF, the
Camera Head does not boot up even if turning ON the power on the Camera Head side.
・ Camera :
13.3 Precautions
A When the system is powered on as SINGLE MODE switch on the AUX board is off, it starts to show
"alert" on Picture Monitors and OCP.
In this case, set the SINGLE MODE switch on the AUX board On, then reboot CCU so the "alert"
disappears.
Depending on the timing, it is possible that the Camera control cannot be recognized as showing "OFF
B
LINE" on the Slow Controller display. In this case, reboot the Slwo Controller first.
If it boots up properly, Time Code is displayed on the Slow Controller. If it does not work, please reboot
all the system including the CCU.
Either the Camera Head or the SHED-HDX. Systems can be turned ON first.
56