Table of Contents
Advertisement
8.6.
Status Indicate Portion
①.
Camera Number Indicator
Program Camera Number of connected is displayed.
②.
MASTER PED Indicator
Indicates MASTER PEDSTAL parameter.
③.
KNOB FREE Switch
While pressing this switch, following mentioned knobs set FREE to hold control parameter if
knobs are rotated.
In case of AWB or Auto Setup is executed when R/G/B GAIN knob center is offset, or ABB or
Auto Setup is executed when R/G/B of PED/M.PED is offset, Knob center will be offset from
mechanical center position. Those offset of each parameter can be cleared if you rotate
Knob to mechanical center with pressing this switch.
④.
HEAD POWER Indicator
When the power supply of the camera head is "ON", it lights.
⑤.
OPT Indicator
To indicate optic signal level at fiber optic cable transmission. Optic signal level from Camera
Head to CCU shows on CCU Indicator and the signal level from CCU to Camera Head that
shows on Head Indicator.
Each indicator express five levels of optical signal condition with combination of Green / Red
/ Amber color and ON / OFF / BLINK.
⑥ CABLE Indicator
To indicate optic fiber cable condition between Camera Head and CCU. If any problem is
detected, each indicator turns on.
⑦ ALARM Indicator (Switch)
Alarm lamp will blink when any NG is found on the system by the detection of self-diagnosis
function. When the switch is pushed when blinking, simple Diagnos is displayed on the LCD.
・ OK
・ ATTENTION
・ WARNING
・ NG
・ NON CONNECTION
・ OPEN
・ SHORT
24
Green ON
Amber ON
Amber Blink
Red ON
OFF
Disconnection or breaking cable
Short circuited
Hide quick links:
Advertisement
Table of Contents
