Nac Hi-Moiton II Quick Manual page 53

Synchronizes 2 Cameras as Master and Slave in 3D application. When the
camera boots up, MASTER is automatically set, regardless of the last setting.
ON, OFF
REC TIME EXTEND
OFF prioritizes the image quality at all the Frame Rate setting.
ON prioritizes the Recording Time at all the Recording Speed.
 AUTO DPC
 Function to correct defect pixels
ON, OFF
DPC ON / OFF Defect Pixel Correction. This is automatically turned ON when
booted up, completed DPC correction, and changed CAPTURE. Two DPC
data can be saved, one each for 1080 and 720 CAPTURE.
Creates Correction data by specifying a defect pixel.
AUTO DPC is enabled only after ABB correction. Perform ABB and then
DPC START manually close a lens before AUTO DPC.
In order to validate the correction data when re-booted, the data must be
saved in DPC SAVE.
DPC SAVE Saves the defect pixel correction data created in DPC START.
0 – 1023
LOW THRESH
Corrects pixels that video level is darker than LOW THRESH.
Set to "LOW THRESH < UPPER THRESH".
0 – 1023
UPPER THRESH
Corrects pixels that video level is brighter than UPPER THRESH.
Set to "LOW THRESH < UPPER THRESH".
 CAMERA ID SETUP
PROGRAM NO. OFF, 1 - 99
ID NO. 1 - 40
 IRIS CIRCUIT ADJUST
ADJUST MODE
ON, OFF
Menu to correct an error between the iris value shown on OCP and the
actual index on a lens. When turning ON, the wizard appears. According to
the wizard, adjust the iris value to F2.8 and F16 with the Menu Dial on the
camera head or the Rotary Encoder on OCP. After setting, press
EXECUTE on OCP display. At that time, selecting TEMPORARY makes
the setting to default.
53
DEFAULT：16
DEFAULT：128
Setting for Program and ID number value