Nac Hi-Moiton II Quick Manual page 51

 MIC GAIN CONTROL
-60dB, -50dB, -40dB, -30dB, -20dB, -10dB, 0dB, +4dB
MIC1 STEP
Setting of Gain for MIC1 at Camera rear panel.
-100 - 100 STEP:1
MIC1 FINE
Fine-tuning of Gain for MIC1 at Camera rear panel.
-60dB, -50dB, -40dB, -30dB, -20dB, -10dB, 0dB, +4dB
MIC2 STEP
Setting of Gain for MIC2 at Camera rear panel.
-100 - 100 STEP:1
MIC2 FINE
Fine-tuning of Gain for MIC2 at Camera rear panel.
 H PHASE CONTROL
-100 - +100
H PHASE Setting for Horizontal Phase of GENLOCK and this is available for HD-SDI
out from the rear of Camera Head when in Stand Alone Style.
H PHASE can be controlled from CCU Menu when CCU is connected.
 LENS SELECT
ON, OFF
LENS SERIAL I/F
Setting for ON/OFF of Lens Serial Interface. Set it ON usually
 SYSTEM
BATT WARN VOLT
BATTERY
WARNING Warning displays on VF/PM1/PM2 when the selected Input Voltage on DC IN
Connector recognizes lower voltage
BARS MODE
Setting for Color Bar Signal
BARS MODE
BARS ON
Setting for ON/OFF of Color Bar output
SEMI SELF MODE
Setting ON keeps the following parameters when OCP is disconnected.
Setting OFF turns all the parameters to defaults when OCP is disconnected.
ON/OFF of CAP, BARS, CAL, IRIS, AWB CH, GAMMA, FLARE, MATRIX,
MATRIX CH, BLACK PRESS/STRETCH, KNEE, WHITE CLIP, COLOR SAT,
COLOR CORR, DTL, SOFT DTL, STEP GAIN
Number of GAIN, GAMMA, BLACK GAMMA, FLARE, TOTAL KNEE, R/G/B
CPU SYSTEM
CONTROL
KNEE, WHT CLIP, DTL, HI-LIGHT DTL, SOFT DTL, SKIN DTL, MATRIX,
COLOR CORR, COLOR SAT, WHT SHADE, BLK SET, PED
SEMI REMOTE MODE
Setting for side switches "GAIN","AWB","OUTPUT" when in Stand Alone
style. When ON, side switches become valid, but no control from OCP.
When OFF, no control from camera head, but only from OCP is valid.
10.5 - 13.5V
FULL, MULTI
ON, OFF
ON, OFF
ON, OFF
51