Nac Hi-Moiton II Quick Manual page 31

3-chip high definition high speed camera system
Table of Contents

Advertisement

9.5
Playback
A
Select the Block you want to play back by the numeric key. Once the desired Block is
selected, the Block that has not been played back will display as a still image with a setting of
PLAY POSITION (Refer to the following settings.), and the Block that has been played back
will display with a still image that has been stopped at previous playback. There are 5 ways
to play back as B, C, D, E, F and the Block Status displays during playback.
The block status on the LCD indication section of the slow controller switches to P and ">"
mark blinks.
Ongoing playback continues when the Block is just selected. Then press the PLAY button or
the Jog wheel to actually start playing back the selected Block.
How to change PLAY POSITION settings
1
Press
2
Press
Slow Controller.
3
When POS/CSTM is selected, value setting is displayed at left below of the LCD indication
section.
You can change the value setting by pressing
A numerical value decreases by pressing
.
4
Press
B
When
PLAY button is pressed, the image clip starts playback according to the setting of
PLAY REF SPEED (Refer to the following settings)
How to change PLAY REF SPEED Settings (Select 60 at 1080/59.94i and 720/59.94p, 50 at
1080/50i. Select 30 or 25 for more slow motion effect)
1
Press
2
Press
the Slow Controller.
3
Press
AE
button.
buttons to call the desired PLAY POSITION as you see on the display on the
041-POS/STRT
Displays the head of the image clip
042-POS/CENT
Displays the middle(50%) of the image clip
043-POS/END
Displays the end of the image clip
044-POS/CSTM
Displays the desired PLAY POSITION of the image clip
045-POS/TRIG
Displays the Triggered point
046-POS/CUE
The frame of the CUE point registered last
ENT button to complete the settings.
AE
button.
buttons to call the desired PLAY REF SPEED as you see on the display on
033-PREF/25
25FPS
034-PREF/30
30FPS
035-PREF/50
50FPS
036-PREF/60
60FPS
ENT button to complete the settings.
of the cross-shaped button.
, a numerical value increases by pressing
31

Advertisement

Table of Contents
loading

Related Products for Nac Hi-Moiton II

Table of Contents