Table of Contents
Advertisement
9.4
Recording
A
Select one of Blocks you want to start recording with by pressing the numeric key.
B
Press
REC
blinks on the Block on Block Status Character on PM2 output.
The block status on the LCD indication section of the slow controller switches to R and "@"
mark blinks.
C
Press either
whatever the Block that is being selected, but
selected Block.
D
When
REC
Setting (Refer to the following setting), and starts a new Block Recording according to
Recording Mode Setting (Refer to Chapter 9.3 F).
How to change Trigger Mode Settings (Regularly, END is selected).
1
Press
2
Press
Controller.
・ 011 TRG/STRT
・ 012 TRG/CENT
・ 013 TRG/END
・ 014 TRG/CSTM
3
When TRIG/CSTM is selected, value setting is displayed at left below of the LCD indication
section.
You can change the value setting by pressing
A numerical value decreases by pressing
.
buttons at the same time to start recording, and you will see ●
and
PLAY
REC
or
STOP
button is pressed, the Block Recording stops according to the Trigger Mode
AE
button.
buttons to call a desired Trigger Mode as you see on the display of the Slow
Records after the Triggered point
Records 50% before&after the Triggered Point
Records before the Triggered point
Records before&after according to the desired Triggered point
button to stop recording.
STOP
, a numerical value increases by pressing
29
REC
button functions on
button only functions on the
of the cross-shaped button.
Hide quick links:
Advertisement
Table of Contents
