Nac Hi-Moiton II Quick Manual page 10

5.2. Output video when set to 1080P
When the system format is set to 1080P, unlike 1080I/720P setting, all output images of the
camera head and CCU become the common image.
- When select the LIVE image, all output images become the LIVE image.
- When select the PLAY image, all output images become the PLAY image.
This section explains the switching the output image when set to 1080P.
A Switching between LIVE and PLAY images
The Switching between LIVE and PLAY images is applied to all output images by
performing the following operation.
1. Set the value of the selection item [PM1] of the OCP to either LIVE or PLAY.
2. Press the
3. Select VIDEO OUTPUT MODE on the head menu MENU (1/2) page, select VF OUT
SEL, and then set LIVE or PLAY.
4. Select VIDEO OUTPUT MODE on the head menu MENU (1/2) page, select MON OUT
SEL, and then set LIVE or PLAY.
* When set the PLAY image, VF output becomes the same PLAY image.
Like 1080I/720P setting, you cannot always output LIVE image.
B Switching between recording and playing
When operating recording and playing, the output image is sometimes different from the
image set in 1080l/720P.
●Operation when outputting LIVE image
1. Showing a selected block which is on recording
- Once the trigger is inputted, recording ends and the image switches from LIVE to PLAY
showing still image of the block.
2. Showing a selected block which has been already recorded
- Press
block.
- Press
the block.
- Operate by JOG/SHTL/T-Bar and then switches from LIVE to PLAY showing replay
image of the variable speed of the block.
3. Moving to the other block
- When the other block is selected, LIVE/PLAY image switches according to the status of
the selected block.
- During recording or not recording a selected block, LIVE image output remains.
- If a selected block has been already recorded, the image switches from LIVE to PLAY
showing still image of the block.
●Operation when outputting play image
1. Showing selected block which is on playing
- When the other block is selected, LIVE/PLAY image switches according to the status of
the selected block.
- During recording or not recording a selected block, the image switches from PLAY to
LIVE image output remains.
- If the selected block has been already recorded, a still image of the block is shown.
- If you switch to LIVE image output, PLAY image stops and switch from PLAY to LIVE.
STANDBY button on the slow controller, and set LIVE or PLAY image.
STOP button and then switches from LIVE to PLAY showing still image of the
PLAY button and then switches from LIVE to PLAY showing replay image of
10