Table of Contents
Advertisement
9.13 Non Functional Buttons
The following buttons are not functional.
1
SAVE
2
A1
3
RESET button on TC line
4
2
,
5
2
and
9.14 FACTORY SET of the slow controller MDC
When set FACTORY SET (factory shipment setting) of the slow controller, you perform the
following operation.
You can perform FACTORY SET of the slow controller only with the slow controller.
1.
Set the POWER switch of the slow controller to OFF.
2.
Set the POWER switch on the back surface of the slow controller to ON while pressing three
buttons (the
same time.
3.
Continue pressing three buttons until LCD indication section shows [Initialize ...] indication.
4.
Separate your hand from three buttons, and the indication of LCD indication section advances
with [Initialize ...] -> [Version] -> [SysCfg int ...] -> [Event int ...] -> [System Setup] and confirm
that the slow controller starts normally.
*All the items to perform by the menu operation of the slow controller are replaced by factory
shipment setting when set FACTORY SET of the slow controller.
It is necessary to set the items (such as "the maximum speed of the T-bar", "fixed VAR speed ",
"PREROLL time ") which changed the set value once again.
As for the slow controller, even in the case of the previous version (MDC50T-NAC08
S0130-52), there is not the problem with operation.
But there are following functions restrictions.
The firmware of the slow controller cannot update by the user, so contact your rental agent or
supplier.
button空白
and
A2
buttons on EDIT line
3
and
4 buttons in PORT line (
3
buttons in CUE MODE SEL line
MENU
button,
1
1 and 2
and
2
buttons in the ten-key button section) at the
41
buttons are used in 3D application)
Hide quick links:
Advertisement
Table of Contents
