D-Link DES-3010F Command Line Interface Manual page 180

DES-3026:4#show 802.1x auth_configuration ports 1
Command: show 802.1x auth_configuration ports 1
802.1X
Authentication Mode
Authentication Protocol
Forward EAPOL PDU
Port Number
Capability
AdminCrlDir
OpenCrlDir
Port Control
QuietPeriod
TxPeriod
SuppTimeout
ServerTimeout
MaxReq
ReAuthPeriod
ReAuthenticate
Forward EAPOL PDU On Port : Disabled
CTRL+C ESC q
config 802.1x capability ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure 802.1x capability on ports 1-10:
DES-3026:4#config 802.1x capability ports 1–10
authenticator
Command: config 802.1x capability ports 1–10
authenticator
DES-3000 Series Layer 2 Switch CLI Reference Manual
: Disabled
: None
: Radius_Eap
: Disabled
: 1
: None
: Both
: Both
: Auto
: 60 sec
: 30 sec
: 30 sec
: 30 sec
: 2 times
: 3600 sec
: Disabled
Quit SPACE n Next Page
Used to configure the 802.1x capability of a range of ports on the Switch.
config 802.1x capability ports [<portlist> | all] [authenticator | none]
The config 802.1x command has four capabilities that can be set for each
port. Authenticator, Supplicant, Authenticator and Supplicant, and None.
<portlist>  Specifies a port or range of ports to be configured.
all  Specifies all of the ports on the Switch.
authenticator  A user must pass the authentication process to gain access
to the network.
none  The port is not controlled by the 802.1x functions.
Only Administrator-level users can issue this command.
p Previous Page
176
r Refresh