D-Link DES-3010F Command Line Interface Manual page 48

DES-3026:4#
delete trusted_host
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To delete a trusted host with an IP address 10.48.74.121:
DES-3026:4#delete trusted_host 10.48.74.121
Command: delete trusted_host 10.48.74.121
Success.
DES-3026:4#
enable snmp traps
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable SNMP trap support on the Switch:
disable snmp traps
Purpose
Syntax
DES-3000 Series Layer 2 Switch CLI Reference Manual
Used to delete a trusted host entry made using the create
trusted_host command above.
delete trusted host [ipaddr <ipaddr> | network
<network_address> | all]
This command is used to delete a trusted host entry made using the
create trusted_host command above.
<ipaddr>  The IP address of the trusted host.
network <network_ address> – Enter the network address with
appropriate subnet mask, to be removed from the switch as a trusted
network.
all – Entering this parameter will remove all trusted hosts from the
switch.
Only Administrator-level users can issue this command.
Used to enable SNMP trap support.
enable snmp traps
The enable snmp traps command is used to enable SNMP trap
support on the Switch.
None.
Only Administrator-level users can issue this command.
DES-3026:4#enable snmp traps
Command: enable snmp traps
Success.
DES-3026:4#
Used to disable SNMP trap support on the Switch.
disable snmp traps
44