D-Link DES-3010F Command Line Interface Manual page 26

logout
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To terminate the current user's console session:
ping
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To ping the IP address 10.48.74.121 four times:
DES-3026:4#ping 10.48.74.121 times 4
Command: ping 10.48.74.121
Reply from 10.48.74.121, time<10ms
Reply from 10.48.74.121, time<10ms
Reply from 10.48.74.121, time<10ms
Reply from 10.48.74.121, time<10ms
Ping statistics for 10.48.74.121
Packets: Sent =4, Received =4, Lost =0
DES-3026:4#
DES-3000 Series Layer 2 Switch CLI Reference Manual
Used to log out a user from the Switch's console.
logout
This command terminates the current user's session on the Switch's
console.
None.
None.
DES-3026:4#logout
Used to test the connectivity between network devices.
ping <ipaddr> {times <value 1-255>} {timeout <sec 1-99>}
The ping command sends Internet Control Message Protocol
(ICMP) echo messages to a remote IP address. The remote IP
address will then "echo" or return the message. This is used to
confirm connectivity between the Switch and the remote device.
<ipaddr> – Specifies the IP address of the host.
times <value 1-255> – The number of individual ICMP echo
messages to be sent. The maximum value is 255. The default is
0.
timeout <sec 1-99> – Defines the time-out period while waiting
for a response from the remote device. A value of 1 to 99
seconds can be specified. The default is 1 second.
Pinging an IP address without the times parameter will ping the
target device an infinite amount of times.
None.
22