D-Link DES-3010F Command Line Interface Manual page 83

DES-3026:4#create syslog host 1 ipaddress 10.53.13.94
severity all facility local0
Command: create syslog host 1 ipaddress 10.53.13.94 severity
all facility local0
Success.
DES-3026:4#
config syslog host
Purpose Used to configure the syslog protocol to send system log data to a remote host.
Syntax config syslog {host [all | <index 1-4>]} {severity [informational | warning |
all] | facility [local0 | local1 | local2 | local3 | local4 | local5 | local6 | local7] |
udp_port <int> | ipaddress <ipaddr> | state [enable | disable]}
Description
The config syslog host command is used to configure the syslog protocol to
send system log information to a remote host.
all  Specifies that the command will be applied to all hosts.
Parameters
<index 1-4>  Specifies that the command will be applied to an index of hosts.
There are four available indexes, numbered 1 through 4.
severity  Severity level indicator. These are described in the following:
Bold font indicates that the corresponding severity level is currently supported
on the Switch.
Numerical
Code
0
1
2
3
4
5
6
7
informational  Specifies that informational messages will be sent to the remote
host. This corresponds to number 6 from the list above.
warning  Specifies that warning messages will be sent to the remote host. This
corresponds to number 4 from the list above.
all  Specifies that all of the currently supported syslog messages that are
generated by the Switch will be sent to the remote host.
facility  Some of the operating system daemons and processes have been
assigned Facility values. Processes and daemons that have not been explicitly
assigned a Facility may use any of the "local use" facilities or they may use the
"user-level" Facility. Those Facilities that have been designated are shown in the
following: Bold font indicates the facility values the Switch currently supports.
DES-3000 Series Layer 2 Switch CLI Reference Manual
Severity
Emergency: system is unusable
Alert: action must be taken immediately
Critical: critical conditions
Error: error conditions
Warning: warning conditions
Notice: normal but significant condition
Informational: informational messages
Debug: debug-level messages
79