The IGMP Access Control commands n the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command
config igmp
access_authentication ports
show igmp
access_authentication ports
Each command is listed, in detail, in the following sections.
config igmp access_authentication ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable IGMP Access Control for all ports:
DES-3026:4# config igmp access_authentication ports all state enable
Command: config igmp access_authentication ports all state enable
Success.
DES-3026:4#
DES-3000 Series Layer 2 Switch CLI Reference Manual
IGMP A
Parameters
[all <portlist> ] state [enable|disable]
[all<portlist>]
Used to configure the IGMP Access Control port status on the Switch.
config igmp access_authentication ports [all<portlist> ] state
[enable|disable]
The config igmp access_authentication ports command is used to
enable or disable the IGMP Access Control function for specified ports.
ports specifies a range of ports to be configured.
state enable/disable the radius authentication function on the specified
ports.
Only Administrator-level users can issue this command.
C
CCESS
ONTROL
156
25
C
OMMANDS