D-Link DES-3010F Command Line Interface Manual page 122

Example usage:
To map a static MAC address to hardware queue 3:
DES-3026:4#config cos mac_mapping destination_addr 01-00-D6-
E4-FF-05 class 3
Command: config cos mac_mapping destination_addr 01-00-D6-E4-
FF-05 class 3
Success.
DES-3026:4#
show cos mac_mapping
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To view the current CoS mapping for static MAC addresses:
DES-3026:4#show cos mac_mapping
Command: show cos mac_mapping
MAC Address
-----------------------------------
01-00-D6-E4-FF-05
DES-3026:4#
config cos tos value
Purpose
Syntax
Description
Parameters
Restrictions
DES-3000 Series Layer 2 Switch CLI Reference Manual
Used to display MAC address CoS mapping configuration.
show cos mac_mapping { destination_addr < macaddr > }
Use this command to view a single entry or all entries configured for CoS
MAC address mapping.
destination_addr < macaddr > – Specify a static MAC address entry to view
the current CoS mapping configuration. If no entry specified, all MAC
mapping entries are listed.
None.
Class
Used to map the Type of Service (ToS) value in the IP header of incoming
packets to one of the four hardware queues available on the switch.
config cos tos value <value 0-7> [class <class_id 0-3>]
Use this command to map ToS priority value in the IP header of an incoming
packet to one of the hardware queues on the Switch.
<value 0-7> – Specifies the ToS value in the IP header to be mapped.
class <class_id 0-3> – Specify the hardware queue to which the ToS value is
mapped.
Only Administrator-level users can issue this command.
3
118