D-Link DES-3010F Command Line Interface Manual page 156

enable igmp_snooping
Parameters
Restrictions
Example usage:
To enable IGMP snooping on the Switch:
DES-3026:4#enable igmp_snooping
Command: enable igmp_snooping
Success.
DES-3026:4#
disable igmp_snooping
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable IGMP snooping on the Switch:
DES-3026:4#disable igmp_snooping
Command: disable igmp_snooping
Success.
DES-3026:4#
show igmp_snooping
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
DES-3000 Series Layer 2 Switch CLI Reference Manual
forward_mcrouter_only – Specifies that the Switch should only forward all
multicast traffic to a multicast-enabled router. Otherwise, the Switch will
forward all multicast traffic to any IP router.
Only Administrator-level users can issue this command.
Used to disable IGMP snooping on the Switch.
disable igmp_snooping
This command disables IGMP snooping on the Switch. IGMP snooping can
be disabled only if IP multicast routing is not being used. Disabling IGMP
snooping allows all IGMP and IP multicast traffic to flood within a given IP
interface.
None.
Only Administrator-level users can issue this command.
Used to show the current status of IGMP snooping on the Switch.
show igmp_snooping {vlan <vlan_name 32>}
This command will display the current IGMP snooping configuration on the
Switch.
<vlan_name 32>  The name of the VLAN for which to view the IGMP
snooping configuration.
None.
152